Price: ₹930.00 - ₹799.00
(as of Nov 18, 2022 08:18:39 UTC – Details)
V6 has the following advantages over v5: height: the most obvious change is that the e3dv6 is considerably shorter than the v5. Bore: there’s a consistent 2mm of space for the filament from the moment it goes into the ptfe tube, to when it reaches the nozzle. This results in almost zero jamming chances. Thermistor: the e3dv6 has a simple screw in method for securing the thermistor, instead of using tapes or messy silicone/adhesives. Heater cartridge: an increased point of contact between the heater block reduces the power required and improves heat up times and puts the heater closer to the nozzle. Fan shroud: has a custom injection moulded fan shroud. This makes for a much easier and cleaner install. Nozzle: the most important improvement on the e3dv6 is the new compact design. The v6 adds a second transition. This reduces the amount of torque required to extrude filament and reduces the likelihood of jamming.
Cooling fan: 12V
30X30X10 mm (with fan shroud)
Thermistor:100K NTC B 3950 ±1% ,1m long (with 2 Pin connector)
Heater :12V 40W,1m long.Pneumatic connector : Included in assembly to connect PTFE tube (OD = 4 mm.)..
